Lowbed

Fliegl VTS 400 P

Further information
Chassis, low-bed semi-trailer
Steel welded construction
Turntable with robust ball bearing race, storage box recessed in the turntable
Turntable extension
Foldable rear support
2 chock blocks with holder
Aluminum side impact protection
Splash guards at the rear over the entire width
Extendable widening sections to 3,000 mm (not in the rear slope)
(However, the track width of the construction machinery or vehicles to be transported must not exceed the outer frame width of 2,550 mm)
Storage compartment for wooden planks in the center of the loading area
Wooden planks 70 mm for widening to 3,000 mm
Tie-down points for low-bed trailer
3 pairs of tie-down points, each rated at 10 tons, integrated into the floor at the front
6 pairs of tie-down eyes recessed on the top and sides of the outer frame, each rated at 10 tons
Lajdsi Ri I Ejpfx Al Noc
1 x in the neck area
the rest distributed in between, with a maximum spacing of 1200 mm
1 x in the rear slope
5 pairs of pocket recesses recessed in the outer frame, 70 x 40 mm internally, (can be converted to 5-ton ring tie-down eyes, not included in the scope of supply)
Coupling device, trailer turntable
Drawbar with tested 40 mm drawbar eye
Note! With a 40 mm drawbar eye, the permissible total weight of the truck may be a maximum of 18,000 kg, otherwise a 50 mm drawbar eye is required.
Axles + Suspension
SAF drum brake axles
Axle/chassis laser-aligned to reduce tire wear and fuel consumption
Parabolic suspension with maintenance-free steel-rubber bearing and mechanical axle load compensation at the front and rear (rocker compensation)
Wheels and tires
235 / 75 R 17.5
according to the manufacturer's choice
Steel rims in twin arrangement, factory silver
Braking system
2-line compressed air braking system
Spring-loaded parking brake
2 fail-safe coupling heads at the front, with connecting lines to the towing vehicle
ABS and ALB, with ABS plug at the front, with connecting cable
Attention: The trailer may only be towed by towing vehicles that guarantee the effectiveness of the ABS!
Electrical system
24 Volt, multi-chamber lights, yellow LED lighting on the sides
2 white position lights at the front
2 white/red side marker lights at the rear
2 x 7-pole fail-safe plugs at the front, with connecting cable
1 LED rotating beacon with holder, switched via the parking lights (beacon can be removed)
2 pairs of warning signs, double LED illuminated and extendable to 3,000 mm
Floor
Front area: steel floor
followed by a 70 mm soft wood floor, in the wheel arch area: steel/diamond plate covering
Rear slope with 70 mm soft wood floor
Ramps
Steel ramps 2,800 mm long, 750 mm wide, laterally movable
covered with wood
with spring-assisted support
Operating instructions
An exemption permit is required for an axle load of 10,000 kg, only indivisible loads are possible!!!
The specified total weight is technically possible; depending on the load, the total weight may not be reached while complying with the permissible axle/support and saddle loads. (Poor driving and handling behavior may occur due to incorrect load distribution)
Country of registration / signs
Country of registration: Germany
1 with Dekra approval and certificate (according to §13 EG - FGV)
24/7 service hotline
prepared for a license plate holder, two lines
Contour marking with reflective strips according to ECE R 048, white on the sides and red at the rear
Painting
Frame Ral 3002 carmine red
10-year warranty against rusting
Drawbar: galvanized or black
accordin

The listing was translated automatically. Translation errors are possible.